Product Description
Both SIM-IPE and SIM-ALP2 with cables and a case
SIM-IPE
Same functions as the old but more features. Menu contents now are dynamic and are based on the discovered device. Also now supports Profinet
New user manual and features see here https://www.plccable.com/blog/new-and-improved-version-allenbradley-ethernet-ip-pro-address-explorer-dhcp-and-bootp-server-simipe/
It replaces your computer based BOOTP/DHCP Server and will quickly assign any IP address to any industrial BOOTP or DHCP enabled control device, like Programmable Controller, PLC communication modules, smart switches and I/O adapters.
Functionality
-Detect unknown IP detection
-Set IP address
-Service DHCP/BOOTP requests
-Change static IP address (Target device must comply with Ethernet/IP CIP specification)
-Enable Bootp or DHCP to static or dynamic(Target device must comply with Ethernet/IP CIP specification)
- 10/100 Full/Half duplex support with auto negotiation
- Device info display via Ethernet/IP: Model, Revision, Serial number
SIM-ALP2
Complete troubleshooting kit... This is our electronic display version of our Current Loop Simulator/Generator was developed to assist maintenance personnel and integrators in 4 to 20 mA analog input testing and 0-10 Vdc, troubleshooting and application development for a reasonable cost. Also included is our soft protective case and leads with alligator clips, both sets of leads are included
This is our version of the Fluke 707.... just for a lot less money
Simulate a 2 wire 0-22 mA loop powered device, a 4 wire 0-22mA current source, or a +/- 10VDC signal without an external power supply.
Simulating is easy in 1 or 0.1 mA/V increments by simply clicking the up and down buttons. Each point can be individually calibrated to suit your needs.
Functionality
0-22 mA 2-Wire Device
0-22 mA Current Source
+/- 10 V Voltage Source
Power Supply
Internal Power
Battery 2xAA
Ni-MH or Alkaline
2-Wire Current
12-30V DC External Power
Current Output
Output Range 0mA to 22mA
Fixed Steps 1mA or 0.1 increments
Output Accuracy ±1% of full scale
Load Range 0-500 Ohm
Voltage Output
Output Range +/- 0V to 10V
Fixed Steps 1V or 0.1V increments
Output Accuracy ±1% of full scale
Minimum Load 20kOhm
Protection
Reverse Polarity,
Over-current, Open Wire,
Excessive Loop Voltage
